Zimbabwe reference library   /   Independent information
Aluminium Zimbabwe
Tutorials / Guide 09

Cutting lists and quantity estimates: a worked aluminium ordering tutorial

Learn the difference between a conceptual material total, a usable cutting plan and an approved manufacturing schedule.

A total length is not yet an order

If a project needs several pieces, adding their lengths gives a useful starting total. It does not account for available stock lengths, cutting losses, end trimming, defects, process allowances or which pieces can be combined efficiently. Nor does it prove that the dimensions are suitable for the intended assembly. Keep quantity arithmetic separate from engineering design.

Begin with an approved piece list. Give each item a reference, product or profile identity, finished length, quantity and drawing revision. State the unit. A mixture of millimetres and metres can cause an expensive error, while repeated names such as “side piece” make it difficult to know which item was changed.

Work through a fictional example

Suppose an educational example requires eight pieces at 1.2 m and six pieces at 0.8 m of one profile. The nominal total is (8 × 1.2) + (6 × 0.8) = 14.4 m. If a supplier offers 6 m stock lengths, three lengths provide 18 m in total. That arithmetic alone does not establish an efficient or feasible cut arrangement.

A fabricator must allow for the real cut width, trimming, clamping and process needs, then lay out pieces on each stock length. In this invented case, two groups of four long pieces and one group of six short pieces each sum to 4.8 m before such allowances. The unused nominal length is not automatically all waste; some may be a reusable offcut.

Define yield and cost consistently

If 14.4 m of required pieces comes from 18 m purchased, the simple nominal length yield is 14.4 ÷ 18 × 100 = 80%. This deliberately simplified figure ignores real cutting allowances and any useful offcuts. State that definition beside the number. A workshop comparing yield by mass, finished parts or reusable stock may report a different figure.

Suppose those three fictional lengths cost 90 units delivered. Dividing by 14.4 m gives 6.25 units per nominal metre of required pieces, before fabrication, finish, rejects and other costs. These are learning numbers, not Zimbabwe market prices. The exercise shows why the purchase price per stock metre is not always the cost per useful finished metre.

Turn the worksheet into a controlled schedule

Ask the fabricator to confirm the actual stock lengths and cutting allowances and review a nesting or cutting plan before ordering. Identify which offcuts will be retained and how they will be labelled. Separate different profiles, alloys, tempers and finishes even when their dimensions appear similar. Avoid mixing material identity for the sake of a superficially higher yield.

For a Zimbabwe project, confirm the product sizes actually available from the intended supplier and the practical transport limits to your site. Review a revised schedule whenever dimensions or quantities change. This tutorial teaches estimation and record discipline; it does not provide a design for a window, structural member, electrical component or other safety-critical assembly.

  • Use a numbered list with units and drawing revision.
  • Group only genuinely identical material specifications.
  • Include actual cutting and process allowances.
  • Distinguish reusable offcuts from discarded material.
  • State the definition behind yield and unit-cost figures.

Sources & further reading

Use these references to check the underlying guidance and any current local requirements. Practical worksheets and illustrative examples in this guide are original educational material.

  1. Aluminum Extruders Council — extrusion features and benefits
  2. The Aluminum Association — alloy and temper standards

This guide is general information. Source notes are not a claim of independent professional review.